|
|
Post by juniorgts86 on May 21, 2011 11:02:13 GMT -5
hey guys i recently bought a blacktop 20v and since i have a aftermarket ecu i rather just swicth wiring cus i dont wanna hack up my firewall. does anyone know whats what on this setup so i can run this motor already. plus my vvt sensor is broke  i know if any1 has 1 laying around that wud be super. |
|
|
|
Post by 305rolla on May 21, 2011 13:59:29 GMT -5
a lil word of advice for next time when you buy a 20V MAKE SURE YOU BUY IT WITH EVERYTHING ON IT AND NOTHING BROKEN. cause its going to be bitch to find things for it cause poeple know how hard it is to get parts for these motors and they are going to want a good amount of money for the parts but good luck with ur 20v.
|
|
|
|
Post by chik0 on May 21, 2011 22:47:57 GMT -5
where u located? as far as wiring your going to have to get that custom done for the aftermarket ecu you brough.as far as the vvt sensor, i forget what car you can get it off here in the states.if i get a chance ill look, but google it, i think it was club4ag.com where i found the talk about it
|
|
|
|
Post by juniorgts86 on May 28, 2011 20:28:15 GMT -5
i have the whole wiring swap for it btw. i was wondering a way i can keep my afm ecu too. im located in winter haven area. near lakeland, i hve everything so i just need the vvt sensor only to complete the swap
|
|
i know if any1 has 1 laying around that wud be super. 
Aww man, at least you tried. What are you planning to try next?