Post by plumbo6 on Aug 2, 2011 14:14:16 GMT -5
OK a little post about this 
stuff you need :
screwdriver ( flat )
heating gun
paint
windshield glue
1. heat the lamp on the rear side after the edge. BE CAREFUL! do not heat it too much! the clear plastic on the front of the lamp will melt if its plastic.
2. use the screwdriver to flip up the front of the lamp. take your time, the tape\glue will slip out after some time.
3. now the front is off, cover up the reflector in the lamp .
4. sanding with 500 paper
5. wash with silicone remover
6 paint
7. remove the cover on the reflector .
8 . put a thin strip of windshield glue on the edge of the lamp where the front is going.
9. put the front back on and let it dry . ( it has to be where it was before you took it of . !! )
pics :
from my delsol :
on my corolla gt :
stuff you need :
screwdriver ( flat )
heating gun
paint
windshield glue
1. heat the lamp on the rear side after the edge. BE CAREFUL! do not heat it too much! the clear plastic on the front of the lamp will melt if its plastic.
2. use the screwdriver to flip up the front of the lamp. take your time, the tape\glue will slip out after some time.
3. now the front is off, cover up the reflector in the lamp .
4. sanding with 500 paper
5. wash with silicone remover
6 paint
7. remove the cover on the reflector .
8 . put a thin strip of windshield glue on the edge of the lamp where the front is going.
9. put the front back on and let it dry . ( it has to be where it was before you took it of . !! )
pics :
from my delsol :
on my corolla gt :
)
Aww man, at least you tried. What are you planning to try next?