Post by SlowRolla on Aug 11, 2011 10:25:25 GMT -5
Hey guys, figured I share this with those of you who like to DIY. I have less than $10 into the project. I had a super detailed step by step guide...and the power went out before I could save it.:mad: So for now, just went basic on the instructions, but should be fairly simple to figure it out IMO. Hope you guys enjoy!
Cantex 2" box adapter 5133720(Found in the electrical department at Lowes):
Vent with bottom 6 fins removed:
After sanding inside the adapter until gauge fit snug and sanded face of adapter smooth:
Its coming together!
Tape up inside, paint(probably better matches out there) and then epoxy gauge to vent:
Make room for wiring and tubing:
Place gauge back and wire up. Sit back and enjoy!
Cantex 2" box adapter 5133720(Found in the electrical department at Lowes):
Vent with bottom 6 fins removed:
After sanding inside the adapter until gauge fit snug and sanded face of adapter smooth:
Its coming together!
Tape up inside, paint(probably better matches out there) and then epoxy gauge to vent:
Make room for wiring and tubing:
Place gauge back and wire up. Sit back and enjoy!
Aww man, at least you tried. What are you planning to try next?
