chevytoyota
New Member
North Carolina Chapter Member
Posts: 23
|
Post by chevytoyota on Sept 27, 2011 5:40:46 GMT -5
Is the oil sender on a 1980 3tc required by the ecm to run? I want to install an after market mechanical guage but I don't want to have a "tree" sticking out of the side of my block. If it is required for operation, where is a good place to stab the new one? Also, mechanical temp guage, the stem is too long to put in the thermostat housing, any ideas? Thanks guys, this site rulzzzzz
|
|
|
Post by Rinconrolla on Sept 27, 2011 8:48:42 GMT -5
Oil sending unit you can put a gauge to it , all that does in one of two thing oil temp or pressure , the temp guage if you send a pic to see what you mean the stem is to long that would help
|
|