|
Post by Rinconrolla on Apr 2, 2015 12:58:44 GMT -5
This is a DIY on a 2000 Infiniti I30 removing and replacing a outer tie rod end . Remove the cotter pin from the bottom Then you can remove the castle nut Then with a outer tie rod tool you can pop off the part from the spindle Remember to count or mark where the old outer tie rod end was so that you can get it as close as you can before you get a alignment Loosen the locking nut then remove the outer tie rod Once you are done with the steps the you can put everything back and head to your local alignment shop and get it adjusted correctly If you don't get it aligned you will eat your tires More DIY @ rinconrolla98.blogspot.com/2015/04/diy-front-outer-tie-rod-end-2000.html .
|
|