Gus 4age20v
New Member
Virginia Chapter Member
Posts: 104
|
Post by Gus 4age20v on Sept 23, 2010 18:09:17 GMT -5
I'm lookin to build a high rev stroked motor!! Need some imput on wat rods pistons block crank head valve train etc... Give me me some ideas on wat to use?? I was thinkin about startin wit a 7afe block and going from there
|
|
pinoyrollarida
New Member
Nevada Chapter Member
silver 9th gen
Posts: 317
|
Post by pinoyrollarida on Sept 23, 2010 18:23:30 GMT -5
just do high comp 7age build
|
|
Gus 4age20v
New Member
Virginia Chapter Member
Posts: 104
|
Post by Gus 4age20v on Sept 23, 2010 18:54:55 GMT -5
Its gunna be a frankinstein build
|
|
pinoyrollarida
New Member
Nevada Chapter Member
silver 9th gen
Posts: 317
|
Post by pinoyrollarida on Sept 23, 2010 19:27:17 GMT -5
yea but fe engines fuel cut is 6300 and u want high rev so u almost gotta go with the ge head unless that head u got was ported for high rpm
|
|
Gus 4age20v
New Member
Virginia Chapter Member
Posts: 104
|
Post by Gus 4age20v on Sept 23, 2010 22:05:25 GMT -5
Well I wasn't neccisaliary gunna do a all 7afe or all one single type and if I don't use my head its all good
|
|
Gus 4age20v
New Member
Virginia Chapter Member
Posts: 104
|
Post by Gus 4age20v on Sept 24, 2010 21:41:54 GMT -5
Any imput guys come on any ideas will help I'm wana get the most bang for my buck I don't wana spend a lot doin this wana be able to get this stuff out of my local yards and just start buildin
|
|
turbobigport
New Member
North Florida Chapter Member
Posts: 48
|
Post by turbobigport on Sept 27, 2010 7:53:28 GMT -5
9age 8)
|
|
Gus 4age20v
New Member
Virginia Chapter Member
Posts: 104
|
Post by Gus 4age20v on Sept 27, 2010 10:07:38 GMT -5
|
|
pinoyrollarida
New Member
Nevada Chapter Member
silver 9th gen
Posts: 317
|
Post by pinoyrollarida on Sept 27, 2010 11:38:49 GMT -5
How the hell would u build a 9age?
|
|
turbobigport
New Member
North Florida Chapter Member
Posts: 48
|
Post by turbobigport on Nov 2, 2010 22:48:45 GMT -5
lol with some big money haha
but for a nice budget build i would use a 7a block crank, h beam forged rods, 11.1 forged pistons, 20v blacktop head, either use the map sensored blacktop harness or convert a map 7a harness so you can retain the knock sensor useage and if you got money just buy a standalone...standalone is not necessary but it will make things easier to make daily driveable, more power and easy to tuck the harness that way
|
|
|
Post by 93geoprizm on Nov 19, 2010 16:59:51 GMT -5
|
|
|
Post by kiyo1990 on Nov 19, 2010 23:50:35 GMT -5
turbo has a intelligent idea.
|
|